Shulou(Shulou.com)06/02 Report--

Xiaobai must see: ultra-simple Trunk small experiment, a look to understand one. Experimental environment

Lab environment: GNS3, router c2691

two。 Experimental topology diagram

three。 Experimental procedure

First of all, configure vlan and interface. First set up the vlan as shown in the picture.

Then assign the interface of sw1 to the corresponding vlan

Then we do the same thing with sw2. As shown in the picture.

Then we are going to set trunk on the f1amp 2 interface of sw1, as shown in the figure

Next, make the same setting for sw2's f1amp 2 interface, as shown in the figure

Finally, we will set the ip address to the PC. The following figure shows the settings from pc1 to pc4 in turn.

At the end of the experiment, we can try to ping each other by ourselves and grab the package with wireshark to see the experimental results. Over!

Welcome to subscribe "Shulou Technology Information " to get latest news, interesting things and hot topics in the IT industry, and controls the hottest and latest Internet news, technology news and IT industry trends.