Shulou(Shulou.com)06/01 Report--

This article mainly shows you the "RaspberryPI 3 system installation and sample analysis of common problems", the content is easy to understand, well-organized, hope to help you solve your doubts, the following let the editor lead you to study and learn "RaspberryPI 3 system installation and sample analysis of common problems" this article.

In fact, I thought the system installation was very easy, of course, it was really very simple, but I encountered a speechless pit during the installation process and it took me half a day. The SD card given by the seller is of poor quality and cannot be recognized by raspberry.

I no longer need to write the installation of the system by myself, borrowing from the official website, just adding some key explanations.

Https://www.raspberrypi.org/documentation/installation/installing-images/README.md

Check in advance: push the standby SD card into the raspberry slot and observe the status of the LED. If the SD is correctly identified and available, the LED will have a flashing green light or red and green. (the SD card I used remained red after it was inserted into the slot, and the burned system could not log in. Of course, it was actually an unidentified card.)

This resource explains how to install a Raspberry Pi operating system image on an SD card. You will need another computer with an SD card reader to install the image.

We recommend most users download NOOBS, which is designed to be very easy to use. However, more advanced users looking to install a particular image should use this guide.

Download the image

Official images for recommended operating systems are available to download from the Raspberry Pi website Downloads page.

Alternative distributions are available from third-party vendors.

If you're not using Etcher (see below), you'll need to unzip .zip downloads to get the image file (.img) to write to your SD card.

Note: the Raspbian with PIXEL image contained in the ZIP archive is over 4GB in size and uses the ZIP64 format. To uncompress the archive, a unzip tool that supports ZIP64 is required. The following zip tools support ZIP64:

7-Zip (Windows)

The Unarchiver (Mac)

Unzip (Linux)

Writing an image to the SD card

You will need to use an image writing tool to install the image you have downloaded on your SD card.

Etcher is a graphical SD card writing tool that works on Mac OS, Linux and Windows, and is the easiest option for most users. Etcher also supports writing images directly from the zip file, without any unzipping required. To write your image with Etcher:

Download Etcher and install it.

Connect an SD card reader with the SD card inside.

Open Etcher and select from your hard drive the Raspberry Pi .img or .zip file you wish to write to the SD card.

Select the SD card you wish to write your image to.

Review your selections and click 'flashworthy' To begin writing data to the SD card.

In the community, many players also recommend another soft, compact and easy-to-use software: Win32DiskImager

After the system successfully writes the SD, insert the SD card in the unpowered state, connect the monitor HDMI (if necessary), the network cable (wired), and then power on.

When the raspberry pie indicator flashes red and green, the system should boot normally.

If you have a monitor, log in directly with pi/raspberry.

To log in using SSH, you need to log in to the router management interface to view the IP of raspberrypi.

If you have experience with Linux, the SSH connection should be very clear.

Use putty or openssh:

Ssh pi@

Welcome to subscribe "Shulou Technology Information " to get latest news, interesting things and hot topics in the IT industry, and controls the hottest and latest Internet news, technology news and IT industry trends.