Shulou(Shulou.com)06/01 Report--

This article will explain in detail how to set up boot service in CentOS. The content of the article is of high quality, so the editor will share it with you for reference. I hope you will have a certain understanding of the relevant knowledge after reading this article.

You can modify the boot configuration simply by modifying:

Vi / etc/sysconfig/network-scripts/ifcfg-eth0

As shown in the picture

File, change ONBOOT= "no" to yes, so you don't have to connect manually next time.

DEVICE= "eth0": interface

HWADDR= "00VOUR 00VOUR 00RUTION": hardware address

NM_CONTROLLED means the parameter of network manger. Yes takes effect in real time. There is no need to restart the ENI immediately after modification.

ONBOOT= "yes": indicates whether the network card is activated when the system is started. Only the network card in the active state can connect to the network and communicate with the network.

So much for sharing about how to set up the boot service in CentOS. I hope the above content can be helpful to you and learn more knowledge. If you think the article is good, you can share it for more people to see.

Welcome to subscribe "Shulou Technology Information " to get latest news, interesting things and hot topics in the IT industry, and controls the hottest and latest Internet news, technology news and IT industry trends.