Shulou(Shulou.com)06/01 Report--

First, plug the PCI wireless network card into PC, then boot into winbox, open the interface main menu, and check whether the wireless network card is supported and recognized by ROS.

Next, select Wireless and click according to the steps in the figure. RouterOS can connect to the wireless network without a password by default, so create a new security solution, and then pay attention to the red box. RouterOS supports WEP, and choose the place of Mode, but WEP is not × × complete, it is better to choose dynamic keys, that is, to use WPA.

Next, we are ready to set the working mode of the wireless network card.

1. Choose the working mode of the network card, and remember to choose ap bridge.

two。 Enter the ID of the wireless network, that is, the network name that the terminal gets when searching for the wireless network.

3. If you choose the frequency band of the wireless network card, you can search the Internet for some information about the 2.4G wireless network and know what to choose.

4. Select the working frequency of the wireless network card. The details are as follows:

5. Security scheme, select the previously established security scheme

6. In fact, it doesn't matter if we choose the region, but we are good people, so we'd better choose it.

The rest basically need not be changed. In fact, there are some data that can be used for reference about the previous choice of wireless frequency, such as the following figure:

1. Click Freg Usage...

two。 Eject Frequency Usage... Dialog box, then click Start

3. This will show the occupation of the current 2.4G network frequency around here. Referring to the frequency table above, it is better to choose the frequency that is not occupied, or if the signal is relatively weak, the estimation speed can be faster, even if someone uses the frequency.

However, it should be noted that selecting channels from 1 to 11 is basically not a big problem. If you choose channels above 11, it depends on the setting of the wireless network card of the terminal, because many network cards will disable channels above 11 by default. Please refer to the following figure:

Then select Snooper...:.

Then the Snooper dialog box pops up, as shown below:

1. Click Stations

two。 Click Start again

You can see the occupancy frequency, SSID, signal strength and other information of the existing AP around. Here, you can basically confirm that the wireless network setting of RouterOS is successful.

Next, set up DHCP. First, set an IP address for the wireless network card and open the ip main menu-- address.

Then set up a pool of ip addresses to be assigned to wireless clients for use

Set up the DHCP server

Set DHCP related options, gateway, DNS, etc.

OK, after setting up, the wireless client can connect.

Welcome to subscribe "Shulou Technology Information " to get latest news, interesting things and hot topics in the IT industry, and controls the hottest and latest Internet news, technology news and IT industry trends.