Shulou(Shulou.com)05/31 Report--

In this article, the editor introduces in detail "how to network in CentOS-NAT mode". The content is detailed, the steps are clear, and the details are handled properly. I hope this article "how to network in CentOS-NAT mode" can help you solve your doubts.

First, the preparation work outside the virtual machine

1. Installed centos virtual machine

2.centos virtual machine network mode is nat

3.vm-Edit-Virtual Network Editor settings are as follows

4. Nat and dhcp services in vm are enabled in computer-management-service.

II. Internal settings of virtual machines

1. Open centos

two。 Command: setup

(next is the graphics configuration process)

3. Go back to the command interface-check vi / etc/sysconfig/network-scripts/ifcfg-eth0

4. Modify onboot=yes

5. Restart eth0 (there are many ways to do this, just give an example below)

Ifup eth0

6. Ping physical host ip ping www.baidu.com

Third, successful networking (if there are any problems in the above article, you are welcome to put forward suggestions for improvement in the comments! )

After reading this, the article "how to connect to the Internet in CentOS-NAT mode" has been introduced. If you want to master the knowledge points of this article, you still need to practice and use it yourself. If you want to know more about related articles, welcome to follow the industry information channel.

Welcome to subscribe "Shulou Technology Information " to get latest news, interesting things and hot topics in the IT industry, and controls the hottest and latest Internet news, technology news and IT industry trends.