Shulou(Shulou.com)05/31 Report--

Hello everyone, Lin Fei to answer the above questions for everyone, how to set up a computer dual hard disk, computer dual hard disk many people do not know, now let us take a look at it!

1, the current computer users will generally install two hard disks on the computer, SSD(solid state drive) mechanical hard disk. Why not? Because solid state reads and writes are really fast, but if you use larger solid states to store data, the cost is too high. So buy a slightly smaller solid state to hold both the system and the long-term software, which will allow both the system to run smoothly and the common software to run smoothly. Plus a mechanical disk for storing data. It was simply a way for low-end players to show off and exploit.

2. Compared with the past, it is much easier to install double plates. When installing hardware, you only need to put the hard disk in the case where the hard disk should be, and connect the SATA cable of the power supply and hard disk data cable. The assembly is OK.

3, mechanical hard disk

4. 1: After the hard disk is installed on the computer, boot it. On the desktop, select My Computer, right click "Manage" to enter the computer management interface.

5."Management" enters the computer management interface 3360.

6. 2: Select "Disk Management", and the system will pop up to detect the new hard disk and ask for initialization, as shown in the figure. Click OK to initialize it.

7, the system will eject and detect the new hard disk.

8. 3: Remember the serial number of the disk, such as disk 0 here, select this disk, right click, pop up the menu, and select "New Simple Volume."

9. From the pop-up menu, select New Simple Volume

10,4: Click Next to create disk partitions.

11. Create a disk partition

12, 5: Set the capacity of the first partition. For example, your partition is used to store the game installation directory, generally to a 400G partition is enough. When the setup is complete, click "Next."

Set the capacity of the first partition.

14, 6: Specify the drive letter for this partition. If there is a C drive, the system assigns it to D drive by default. You can also specify manually. When the setup is complete, click "Next."

This partition specifies the disk number.

16, 7: Format partitions. There are partition formatting settings. Only NTFS partition format supports large capacity. Also, you can customize the disk name (label). Use fast format. Click "Next" and the first partition is complete.

17, only NTFS partition format supports large capacity.

18, 8: Repeat steps 3 through 7 above to create the next partition. Note that you need to select undivided capacity. Right-click Create New Partition. After all is established, as shown in the figure.

Repeat steps 3 through 7 above to create the next partition.

20, 9: Now open my computer and you can see each disk of the newly created partition. It is now possible to store files on a large mechanical hard disk.

It is now possible to store files with large capacity mechanical hard disks.

22. After creating a partition, does it feel good to have an additional mass storage disk?

This article is finished and I hope it helps everyone.

Welcome to subscribe "Shulou Technology Information " to get latest news, interesting things and hot topics in the IT industry, and controls the hottest and latest Internet news, technology news and IT industry trends.