Leko Router NW625PLUS Wireless WIFI Relay course
Leike Router Wireless WIFI Relay course
1. The name of the WiFi to be relayed is PDCN, and the password is 12341234. After connecting with a mobile client, you can find the following in the mobile WiFi connection options.
You can see that in the figure above, the encryption method of WiFi is WPA2 PSK, the obtained IP address is 192.168.123.26, and the secondary WiFi network outage is determined to be 192.168.123.
And the gateway device IP (router login IP) is 192.168.123.254
2. Log in to the sub-router used to relay the wireless signal PDCN, Leko
IP address is http://192.168.43.2, login name and password are guest
After logging in, the following figure
Find the wireless setting, mode is repeater (trunk mode), SSID is the name of the WiFi emitted by this router, repeater-ssid is the name of the WIFI to be relayed above, PDCN, and the channel should be the same as the main router!
3. The WiFi name and channel details of the main router can be viewed here.
Wireless Settings-Network list-Click Refresh. You can see the WiFi name and channel information and go back to step 2.
4. Configure the wireless encryption mode and password of the secondary route in the wireless security tab, which needs to be consistent with the primary router.
5. The IP address range of secondary route should be the same as that of the primary route, and both should be set to 192.168.123. (since it is the 43 IP address range of mobile phone hotspots, the setting of 43 IP address range depends on the situation. )
And turn off the DHCP function, if you don't turn it off, there will be address conflicts.
6. This is the end of the setup. You can surf the Internet normally.
Note:
1. If the terminal is set up and cannot surf the Internet, try manually configuring the IP address to the client to see if you can surf the Internet.
2. When configuring a wireless channel, if you cannot change the channel, first try to set it to AP mode, then change the channel, and then change it back to repeater mode.
