Shulou(Shulou.com)06/02 Report--

First, the preparation work outside the virtual machine

1. Installed CentOS virtual machine

2.CentOS virtual machine network mode is NAT

3. VM-Edit-Virtual Network Editor settings are as follows

4. NAT and DHCP services in VM are enabled in computer-management-service.

II. Internal settings of virtual machines

1. Open CentOS

two。 Command: setup

(next is the graphics configuration process)

3. Go back to the command interface-check vi / etc/sysconfig/network-scripts/ifcfg-eth0

4. Modify onboot=yes

5. Restart eth0 (there are many ways to do this, just give an example below)

Ifup eth0

6. Ping physical host ip ping www.baidu.com

Third, successful networking (if there are any problems in the above article, you are welcome to put forward suggestions for improvement in the comments! )

The above is the whole content of this article, I hope it will be helpful to your study, and I also hope that you will support it.

Welcome to subscribe "Shulou Technology Information " to get latest news, interesting things and hot topics in the IT industry, and controls the hottest and latest Internet news, technology news and IT industry trends.