In addition to Weibo, there is also WeChat
Please pay attention
WeChat public account
Shulou
2025-04-02 Update From: SLTechnology News&Howtos shulou NAV: SLTechnology News&Howtos > Internet Technology >
Share
Shulou(Shulou.com)06/01 Report--
This article mainly introduces the setting steps of the luci interface in Openwrt and what is set as a second-level route, which has a certain reference value, and interested friends can refer to it. I hope you can learn a lot after reading this article.
The luci interface can be said to be an important module for visually configuring openwrt, enabling openwrt routers to set various parameters like the routers we normally come into contact with.
We need to be able to compile the luci module in the source code so that when we burn the firmware to the router, we can present the configuration page on the web side. The setting steps are as follows: first, make menuconfig only needs to configure the following parameters. Other Luci are default values, which can be ignored for the time being.
After the configuration, you can compile directly. If you have compiled the source code before, then the compilation of luci should be very fast.
After the compilation is completed, then burn the firmware to the router, the method of burning firmware has been introduced in the previous article, you can refer to it.
Openwrt | procedure for hard repainting TP-LINK TL-WR710 to openwrt development board
After the firmware has been burned, start the board
Then enter the following command on the command line
The luci-related package appears below, indicating that the development board already supports luci.
Here's how to use the openwrt router as a secondary route on the command line so that you can connect to the network.
1. First, close the WAN port uci set network.wan.proto=none2, the gateway points to the superior route uci set network.lan.gateway=192.168.1.13, the dns points to the superior route uci set network.lan.dns=192.168.1.14, turn off the dhcpuci set dhcp.lan.ignore=15 of lan, and apply uci commit.
6. Restart the network service / etc/init.d/network restart after the execution of the above instructions, you can link to openwrt through the web page.
The following command is to start uhttpd/etc/init.d/uhttpd start to thank you for reading this article carefully. I hope the article "the steps of setting up the luci interface in Openwrt and what is set up as a secondary route" shared by the editor will be helpful to everyone. At the same time, I also hope that you will support us and pay attention to the industry information channel. More related knowledge is waiting for you to learn!
Welcome to subscribe "Shulou Technology Information " to get latest news, interesting things and hot topics in the IT industry, and controls the hottest and latest Internet news, technology news and IT industry trends.
Views: 0
*The comments in the above article only represent the author's personal views and do not represent the views and positions of this website. If you have more insights, please feel free to contribute and share.
Continue with the installation of the previous hadoop.First, install zookooper1. Decompress zookoope
"Every 5-10 years, there's a rare product, a really special, very unusual product that's the most un
© 2024 shulou.com SLNews company. All rights reserved.