Shulou(Shulou.com)06/01 Report--

This article will explain in detail the solutions to the shortage of physical memory in VMware. The content of the article is of high quality, so the editor will share it with you for reference. I hope you will have some understanding of the relevant knowledge after reading this article.

After creating a new virtual machine, some partners may pop up the prompt that there is not enough physical memory to turn on the virtual machine with the configured settings. As shown in the figure below, the system prompts you to reduce the memory size of the virtual machine to 20352MB. If you don't have enough physical memory, the virtual machine can't get up.

This is because some partners give the virtual machine a higher configuration when they install the virtual machine system for the first time, so that the memory is as large as possible, and they are worried that the virtual machine will not work. There is nothing wrong with thinking this way, the key is to blindly increase the configuration, it is easy to appear the phenomenon of insufficient physical memory.

Then in view of this problem, this paper gives the corresponding solutions here, hoping to play a guiding role for later partners to encounter similar problems.

1. Turn off the virtual machine and turn off the power supply. Make sure the virtual machine is powered off, as shown in the following figure.

2. Click "Edit Virtual Machine Settings" above, as shown in the red box below.

3. Then you can see the interface in the following figure, which shows the memory size (20480MB) that was specified when the virtual machine was created.

4. That's the problem. You just need to change the memory size to 20352MB, that is, the memory size of the error message, as shown in the following figure.

5. Now restart the virtual machine and start the operation of the virtual machine, as shown in the following figure.

6. I thought this would solve the problem, but unfortunately, the car turned over again

As shown in the following figure. Don't panic, it's not a big problem.

7. The same error is prompted again, but the memory size of the prompt has been reduced by one level again. The same solution, repeat steps 1-6, and continue to compress the memory. Here, set the memory size directly to 16384MB (16GB), as shown in the following figure. Everyone's computer configuration is different, here is just to give a feasible method, the specific configuration according to their own error situation. Otherwise, it is easy to roll over.

8. After the setup is complete, the device information of the virtual machine can be seen on the VMware home page as before, but the memory is reduced, as shown in the following figure.

9. Click "start the virtual machine" again at this time, as shown in the following figure. At this point, you can see that the virtual machine can start normally.

Seeing this, the editor believes that the next time my friends encounter the problem of "insufficient physical memory, unable to use the configured settings to turn on the virtual machine", they should know how to solve it.

This is the solution to the shortage of physical memory in VMware. I hope the above content can be helpful to you and learn more knowledge. If you think the article is good, you can share it for more people to see.

Welcome to subscribe "Shulou Technology Information " to get latest news, interesting things and hot topics in the IT industry, and controls the hottest and latest Internet news, technology news and IT industry trends.