Shulou(Shulou.com)06/01 Report--

This article will explain in detail how to deal with the failure of computer startup according to the BIOS information displayed. The editor thinks it is very practical, so I share it with you as a reference. I hope you can get something after reading this article.

In the daily use of computers, we often encounter failures in which the computer cannot start and the boot system fails to boot, which is all related to the hard disk. When the hard disk fails, BIOS will give us some English prompts to remind us of the specific failure of the hard disk. Below we take the use of the more common Award BIOS as an example to explore how to deal with the failure of computer unable to start and boot system startup failure according to the BIOS information displayed on the display screen.

1. Hard disk controller failure (failure of hard disk controller)

This is one of the most common error prompts, and when this happens, you should carefully check whether the connection plug of the data cable is loose, whether the connection is correct, or whether the hard disk parameters are set correctly.

2. Date error (data error)

When this happens, there is an unrepairable error in the data read from the hard disk or a bad sector on the disk. At this point, you can try to start ScanDisk to scan and correct the logical errors in the sector. if the bad sector is a physical bad track, you need to use a special tool to try to fix it.

3. No boot sector on hard disk drive (no boot sector on the hard disk)

This may be due to the destruction of the boot sector on the hard disk, usually because the boot area of the hard disk system has been infected with a virus. In this situation, we must first thoroughly check and kill the virus in the system with the latest version of antivirus software, and then use software with boot sector recovery function such as KV3000 to try to recover the boot record. If you are using a WinXP system, you can start the recovery console and call the FIXMBR command to restore the primary boot sector.

4. Reset Failed (hard disk reset failure), Fatal Error Bad Hard Disk (hard disk fatal error), DD Not Detected (hard disk not detected) and HDD Control Error (hard disk control error)

When any of the above prompts appear, it is generally the fault of the hard disk control circuit board, the hard disk interface circuit on the motherboard or the mechanical part of the disk body. in this case, professionals can only be asked to overhaul the corresponding control circuit or directly replace the hard disk.

Although the failure of the computer to start and the boot system failure is largely caused by the failure of the hard disk, it may also be due to other hardware. therefore, it is necessary to make dual preparations when there is a failure in which the computer cannot start and the boot system fails to boot.

This is the end of the article on "how to deal with the failure of computer startup according to the displayed BIOS information". I hope the above content can be of some help to you, so that you can learn more knowledge. if you think the article is good, please share it for more people to see.

Welcome to subscribe "Shulou Technology Information " to get latest news, interesting things and hot topics in the IT industry, and controls the hottest and latest Internet news, technology news and IT industry trends.