Shulou(Shulou.com)06/01 Report--

This article will explain in detail how to solve the problem of "bad pbr sig" in solaris10 installation. Xiaobian thinks it is quite practical, so share it with you as a reference. I hope you can gain something after reading this article.

When installing solaris10 on a PC, everything went smoothly, but when the installation was complete and booting from disk, the red "bad pbr sig" was displayed in the lower left corner of the screen. Reloading several times has no effect. Later, when using FDISK to do disk partitioning, a PRI DOS partition and SOLARIS partition were built, and then the problem was solved. The system was installed and booted normally.

In addition, I use this ISO is DVD format, seems to be less files, installation can not be installed with graphical interface. Media errors are reported at the beginning of installation. Later, when I checked on the Internet, I said that DVD format can only be installed with text interface. Since there is no CD format system disk in hand, there is no verification.

DOS PRI is a partition used as a boot for X86 and must be created separately from Solaris partitions.

As for the DVD ISO can not be graphical, in fact, not, I also encountered the same problem, but tried a few times, the last time out of the graphical interface, always feel that there is a problem with the choice of somewhere, not the disk itself. Of course, it is also possible that the installation disk itself has certain problems with the identification of the graphics card, there is no CD disk, do not verify, but DVD is definitely graphic installation. Note: BS realtek's 1000MB PCIE NIC does not have a driver under Solaris!

If you boot into single mode again with the CD, format, and see that the Solaris S2 of your hard drive starts with a cylin of 1 instead of 0, you simply change the starting cylin of this S2 to 0, change the size to the full Solaris FDISK size, and reinstall grub-m /boot/grub/stage1 /boot/grub/stage2/dev/rdsk/c0d0s0.

Bad PBR sig disappeared after restart.

About "how to solve the problem of"bad pbr sig"in solaris10 installation", this article is shared here. I hope the above content can be of some help to everyone so that you can learn more knowledge. If you think the article is good, please share it for more people to see.

Welcome to subscribe "Shulou Technology Information " to get latest news, interesting things and hot topics in the IT industry, and controls the hottest and latest Internet news, technology news and IT industry trends.