Shulou(Shulou.com)05/31 Report--

This article mainly introduces how to install the memory bar on the computer, which has a certain reference value. Interested friends can refer to it. I hope you will gain a lot after reading this article.

1. First of all, pull the plastic pins on both sides of the memory slot corresponding to the memory (often referred to as the "safety bolt") to the outside, so that the memory bar can be inserted.

Tip: on any motherboard that supports RDRAM, you can see that RIMM memory slots appear in pairs. Because RDRAM memory sticks cannot be used alone, they must appear in pairs. RDRAM requires that the RIMM memory slots must be full, and the spare RIMM memory slots must be plugged into the transfer board (also known as the "Terminator") in order to form a loop.

two。 Pick up the memory stick and aim the gap in the pin of the memory bar at the bulge in the memory slot, or align the position marked with number 1 on the edge of the gold finger of the memory bar at the position marked with number 1 in the memory slot.

3. Finally, with a little effort, insert the memory strip vertically into the memory slot and press it until the safety plugs at both ends of the memory slot automatically clamp the gap on both sides of the memory strip.

Thank you for reading this article carefully. I hope the article "how to install memory bars on a computer" shared by the editor will be helpful to everyone. At the same time, I also hope that you will support and pay attention to the industry information channel. More related knowledge is waiting for you to learn!

Welcome to subscribe "Shulou Technology Information " to get latest news, interesting things and hot topics in the IT industry, and controls the hottest and latest Internet news, technology news and IT industry trends.