Shulou(Shulou.com)06/02 Report--

# speaking of soft routing, when do we usually use it

# it is generally used when the enterprise capital is not very rich, or when a wired network is set up, and you want to use a router to control wireless.

In fact, we can also buy another hardware router, but considering the cost, we still use soft routing, because its construction is simple, convenient and cheap.

So how was it built?

Required materials: 1.1sets of pc, the premise must be one hard disk / TF card, two network cards / / one network card is connected to the external network port, that is, the wan port, and one network card is connected to the internal network port, that is, the lan port

two。 A 4G/8G flash drive / with Chinese cabbage, u boot, old peach-can be done.

3. A router image of .gho

# do the steps

# make a U disk into a boot disk and omit / / because everyone should

# insert the USB disk into the computer, then restart the computer, enter bios, and select the USB disk to start, as shown in the following figure

Enter the pe interface and select manual ghost when you enter the desktop, as shown in the following figure

Local disk from image / / Select the router's .gho image file from the local source disk

As shown below: select the router image of .gho

# Select the target disk / / the disk in which you want to install the image file

# the target drive disk believes the information. Generally keep the default

# Select yes installation

# when the installation is finished, click reset computer / / restart

# after reboot, as shown in the following figure: this pc has become a router

# as shown in the figure above, its default ip address is the 192.168.1.1 80 segment.

# so how is it configured with the web interface, as follows:

# connection of the line

Plug the cable converted from the optical cat into the wan port of the pc router, connect your host to the lan port of the pc router, and set it to the same network segment / / for example, 192.168.1.2

# originally, cross lines were used to connect two pc, but now they are all adaptive, so it is recommended that you use a straight line.-easy to remember.

# next, go to the web interface to configure

Http://192.168.1.1 is shown in the following figure

# the web interface has been entered as shown in the figure above. Enter the account number and password. Default is admin and admin.

# the figure above shows that we have successfully entered the web configuration interface

# generally, it is configured first, surfing the Internet, static, dynamic and ppoe

# I think everyone should be able to configure it, even if not, research and research.

# the function of this router is very strong, and I don't know how to do some of it. Go down and study it.

-

End

Welcome to subscribe "Shulou Technology Information " to get latest news, interesting things and hot topics in the IT industry, and controls the hottest and latest Internet news, technology news and IT industry trends.