Shulou(Shulou.com)06/01 Report--

Recently, the unit wants to upgrade a building without wiring, and we are asked to carry out the layout of the network first.

After receiving the task, we carefully analyzed the structure of the building and discussed several feasible schemes.

First, draw a network cable from the main computer room, build a cabinet when you arrive at the destination building, join a switch, and then arrange it in each room.

Second, draw a network cable from the main computer room, connect to a wireless router after arriving at the destination building, and then use the wireless network to extend to each area, so that the wireless network can be fully covered.

Third, draw a network cable from the main computer room, connect to a switch after arriving at the destination building, connect to each floor, and then connect to the wireless router.

Fourth, a network cable is drawn from the main computer room, and a set of AP system is introduced after arriving at the destination building.

After consultation, it is concluded that various schemes have their own advantages and disadvantages. The ultimate goal is to ensure that employees can make smooth use of the network, especially more and more intelligent terminals, it is agreed that the third plan is more feasible, the network is more stable, the cost is not much. After you have decided on the plan, just do it.

1. Estimated distance

Carefully measure the distance from the main computer room to the destination, from the main computer room to each floor, from each floor to each router. Finally, add some redundancy and get it done.

Finally, after the construction, we found that our estimated length is relatively accurate, sufficient, and not much waste.

2. Preparation of tools

In the process of wiring, we have to use wire slots, clasps, corners, hammers, × × and other tools.

As there is no preset pipe slot in the building, we can only take the open line. In order to be clean and tidy, we choose a flame retardant wire slot to uniformly cut through the slots and fix the wire.

3. Equipment preparation

In the process, we need to go to the cabinet, a switch and several wireless routers.

Based on the number of users, we estimate the approximate number of routers required. To prevent crosstalk between each other, artificially fixed the channel of each router. In order to facilitate wireless routing, reduce the risk caused by changing the network, and achieve network-wide wireless coverage, we set the same name and password for each router. In this way, as long as users enter the network, they can automatically switch to the Internet without switching routers.

4. Training of construction personnel

(1) Safety training in construction

Including the safety awareness and behavior of personnel; the safety of materials.

Because of safety, only the personnel have a sense of safety, correct construction behavior, generally will not occur safety accidents.

(2) in the process of wiring, it is necessary to ensure the safety of the network cable, including no dead knots. When time permits, it is necessary to make a good 8-character in advance, and there should always be personnel to check it in the process of releasing the line, so as to ensure that the network line is in the line of sight of the construction personnel.

When it is ready, it will be carried out.

After the wiring is completed, the RG45 head is used to make the terminal for the network head. Note that the line sequence should be correct and the clamp should be in place. After the completion of the test, correct after the use of line marks for identification. Otherwise, you will end up with a headache in the face of a lot of thread.

The cables in the cabinet should be neat and non-intersecting, so as to achieve the purpose of beauty.

Connect the router that has been set up in advance and test the network.

Select the area where the personnel are more concentrated, the time when the population is dense, and cover all parts as much as possible. Detect the influence of each router's channel to each other.

After everyone's intense construction, we finished all the work in the shortest time and achieved the ideal effect. Looking at the mobile phone from the first floor to the top floor, seamlessly surfing the Internet smoothly, psychological thinking is very beautiful.

Due to the use of wire slots, the overall cleanliness; the use of wireless routers in the building can meet the needs of many people surfing the Internet at the same time, avoiding the addition of routers in a room to cause computers; intelligent wireless terminals can play their own powerful functions.

In the face of the satisfaction of users, the psychology is thinking, for us engaged in the network, the future work has come.

Welcome to subscribe "Shulou Technology Information " to get latest news, interesting things and hot topics in the IT industry, and controls the hottest and latest Internet news, technology news and IT industry trends.