Shulou(Shulou.com)06/02 Report--

The principle and configuration of dynamic routing RIP Protocol 1: the principle of RIP routing Protocol

The ​ RIP routing protocol is based on the distance vector algorithm and uses hop count (metric) to measure the distance to the destination address. It is a distance vector protocol used to exchange routing information between routers and hosts. Routers in this protocol only exchange information with their neighboring routers, and the range is limited to 15 hops.

Second: experimental purpose

Enables one host to dynamically obtain the ip address assigned by another host through the RIPv2 protocol

Three: experimental operation

1. Use a computer equipped with GNS3, open GNS3, pull out three routers and two PCs, link the marks with twisted-pair cables so that you can see them, and open them.

2. Start the configuration now, first configure the addresses for each interface of R1, R2, R3, and then configure the rip protocol.

R1

The same is true for R2 and R3.

3. After they are all configured, check the routing table (show ip route) to see if there are any configuration errors.

4. Finally, configure the ip addresses of the two hosts, ping each other to see if they can communicate with each other, and the experiment is completed.

We can see that the ping is connected, and now the two hosts can communicate with each other. This experiment is completed.

Welcome to subscribe "Shulou Technology Information " to get latest news, interesting things and hot topics in the IT industry, and controls the hottest and latest Internet news, technology news and IT industry trends.