Shulou(Shulou.com)06/01 Report--

This article mainly introduces "SolidWorks simulation how to achieve kayak". In daily operation, I believe many people have doubts about how to realize SolidWorks simulation. Xiaobian consulted all kinds of materials and sorted out simple and easy-to-use operation methods. I hope it will be helpful to answer the doubts about "how to realize SolidWorks simulation". Next, please follow the editor to study!

Let's analyze it first: how can it look like it's rowing? That is, to make the two slurries move and directly control the two pulps. You can do it. You do it.

You can see that there is a red disc connected to a blue rod, and the blue rod is connected to a person's leg. Ah, it is to drive the small disc to rotate and drive it to the pulp one by one.

All right? keep looking down.

After entering the assembly environment, [Assembly]-[insert parts]-[Browse]-select the parts to be put first, and choose the kayak in this assembly.

Note: the first one put in is fixed.

Then insert the parts one by one and carry out [fit]

1. The handle fits with the small shaft section of the hull through [concentric] and [contact]

2. the coordination of the frame.

The front hole of the frame is concentric with the small hole on the edge of the handle.

The right side of the frame is in contact with the left side of the handle.

Select the width fit in the Advanced fit to match the upper and lower sides of the handle with the axle width of the hull.

The result after completion

3. Let people sit in in a similar way

4. here comes the big show. Load the pulp.

First of all, through the [coincident] constraint, the joint is matched with the hull.

Install the second section in the same way.

After loading, before loading, the ball needs to be placed in the section, there is a circular groove in the section, and the ball is placed in the section through contact.

Concentric coordination of arm and pulp

The two sides of the pulp red part coincide with the ball respectively.

Note: the picking of each side must be accurate, otherwise the pulp may fly during the exercise.

Install the second slurry in the same way

Simulation part

It must be done in Motion.

Add the merry-go-round to the handle and select "constant Speed". It is better to slow down the speed.

Simulation result

At this point, on the "SolidWorks simulation how to achieve kayak" on the end of the study, I hope to be able to solve your doubts. The collocation of theory and practice can better help you learn, go and try it! If you want to continue to learn more related knowledge, please continue to follow the website, the editor will continue to work hard to bring you more practical articles!

Welcome to subscribe "Shulou Technology Information " to get latest news, interesting things and hot topics in the IT industry, and controls the hottest and latest Internet news, technology news and IT industry trends.