Shulou(Shulou.com)06/02 Report--

1. Experimental environment: GNS3-1.3.10

Second, the purpose of the experiment is to realize the interconnection of static routes used by VPC.

Third, the experimental steps:

1. First establish the topology as shown in the figure, drag two routers and PCs to the work area, and connect them with a network cable

2. Plan the IP address of router interface and the IP address of PC.

3. Click the start button to turn on all devices

Click on a device icon, and double-click to open their respective tabs

5. Enter conf (space) t in the R1 tab to enter global mode

6. Enter int (space) f0and0 in global mode to enter interface mode

7. Enter the ip (space) address (space) IP address (space) subnet mask in interface mode to configure R1's f0and0 interface.

8. Type no (space) shutdown to enable the interface

9. Then enter int (space) f0gam1 to enter interface mode, continue to enter ip (space) address (space) IP address (space) subnet mask in interface mode, and finally enter no (space) shutdown to turn on the interface

10. Enter ex (ex, exit abbreviation) to return to global mode

11. Enter the address of the next hop of the ip (space) destination network number (space) subnet mask (space) in global mode to configure the R1 static route

12. Configure the IP address and subnet mask and static routes of the two interfaces of R2 as before

13. Enter "IP address (space) subnet mask (space) gateway" in the tab of PC1 to configure PC

14. Configure the PC with the same "IP address (space) subnet mask (space) gateway" in the PC2 tab

15. Enter "ping (space) PC2IP address" in the tab of PC1 to verify whether it can be interconnected.

Here you can see the information fed back from the IP address of PC2, indicating that PC2 and PC2 are interconnected at this time.

Welcome to subscribe "Shulou Technology Information " to get latest news, interesting things and hot topics in the IT industry, and controls the hottest and latest Internet news, technology news and IT industry trends.