Shulou(Shulou.com)05/31 Report--

This article mainly explains the "CentOS6.6 installation case analysis", the article explains the content is simple and clear, easy to learn and understand, the following please follow the editor's ideas slowly in depth, together to study and learn "CentOS6.6 installation case analysis" bar!

1. First, I need to download an iso image of centos. I installed it with virtual machine vmware. It is best to create a blank hard disk with vmware.

two。 After the creation, set up the centos system file in which iso is mounted.

3. Go to this page:

Description:

1.install or upgrade an existing system

Install or upgrade an existing system

2.install system with basic video drive

Basic graphics card drivers are used in the installation process.

3.rescue installed system

Enter system repair mode

4.boot from local drive

Exit the installation and boot from the hard drive

5.memory test

Memory detection

6.press tab to edit options

Press "tab" to edit the options

4. Select skip

5. Click next next

6. Choose English or Chinese single can, some people say choose Chinese will garbled, I tested there is no garbled.

7. Keyboard selection default, next step.

8. Select basic Storage device here

9. Select: yes, ignore all data

10.hostname fill in the form "English first name. Surname"

11. Click on the order of the installation diagram of the network settings

twelve。 Choose Shanghai here, as shown in the figure:

13. Set the password here, if you have a weak password, you will be prompted!

14. Hard disk partition, as shown in the picture, remember the tick below!

15. Create a source driver, as shown in the figure, no problem on the next step.

16. Click: format!

17. Select to write changes to disk.

18. Default, as shown in the picture, and then the next step.

19. Select as shown in the picture.

20. Then check here, you can choose some software packages according to your needs.

21. The next step above is to install the package automatically, and then successfully install it here.

twenty-two。 When those settings are completed, the system will be rebooted.

Note:

Enter the dos interface

Shortcut key: ctrl+alt+f2

Then switch from the dos interface to the graphical interface.

Shortcut key: ctrl+alt+f1

To set the network configuration, you can choose to enter the dos interface or the graphical interface. Here is how to enter the dos interface to set the network configuration.

Here eth0, refers to the first network card interface, if your computer (there are multiple servers, please distinguish)

[sungeek@sungeek network-scripts] $vi / etc/sysconfig/network-scripts/ifcfg-eth0

Here is the configuration:

Device=eth0

Type=ethernet

Uuid=3cac51c4-b05b-47f3-9ce4-a18a75a2eb93

Onboot=yes

Nm_controlled=yes

Bootproto=none

Defroute=yes

Ipv4_failure_fatal=yes

Ipv6init=no

Name= "system eth0"

Hwaddr=00:0c:29:b8:ce:9a

Ipaddr=192.168.0.168

Prefix=24

Gateway=192.168.0.1

Dns1=202.96.134.133

Thank you for your reading, the above is the content of "CentOS6.6 installation example analysis", after the study of this article, I believe you have a deeper understanding of the problem of CentOS6.6 installation example analysis, and the specific use needs to be verified in practice. Here is, the editor will push for you more related knowledge points of the article, welcome to follow!

Welcome to subscribe "Shulou Technology Information " to get latest news, interesting things and hot topics in the IT industry, and controls the hottest and latest Internet news, technology news and IT industry trends.