Shulou(Shulou.com)05/31 Report--

Editor to share with you how to enable redis to allow remote access, I believe most people do not know much about it, so share this article for your reference, I hope you can learn a lot after reading this article, let's go to know it!

Introduction:

We all know that redis only allows local access by default, so what do we do if we want to make redis accessible remotely?

Specific methods:

Opening the redis.conf file is explained in the NETWORK section

# # NETWORK # By default, if no "bind" configuration directive is specified, Redis listens# for connections from all the network interfaces available on the server.# It is possible to listen to just one or multiple selected interfaces using# the "bind" configuration directive Followed by one or more IP addresses.## Examples:## bind 192.168.1.100 10.0.0.The bind 127.0.0.1:: 1 # ~ ~ WARNING ~ If the computer running Redis is directly exposed to the# internet, binding to all the interfaces is dangerous and will expose the# instance to everybody on the internet. So by default we uncomment the# following bind directive, that will force Redis to listen only into# the IPv4 lookback interface address (this means Redis will be able to# accept connections only from clients running into the same computer it# is running). # # IF YOU ARE SURE YOU WANT YOUR INSTANCE TO LISTEN TO ALL THE INTERFACES# JUST COMMENT THE FOLLOWING LINE.# ~ ~ bind 127.0.0.1

Solution: comment out bind 127.0.0.1 to enable all ip to access redis

If you want to specify multiple ip accesses, but not all ip accesses, you can bind

Be careful

Here's another explanation.

# Protected mode is a layer of security protection, in order to avoid that# Redis instances left open on the internet are accessed and exploited.## When protected mode is on and if:## 1) The server is not binding explicitly to a set of addresses using the# "bind" directive.# 2) No password is configured.## The server only accepts connections from clients connecting from the# IPv4 and IPv6 loopback addresses 127.0.0.1 and:: 1, and from Unix domain# sockets.## By default protected mode is enabled. You should disable it only if# you are sure you want clients from other hosts to connect to Redis# even if no authentication is configured, nor a specific set of interfaces# are explicitly listed using the "bind" directive.protected-mode yes

After redis3.2, redis adds protected-mode. In this mode, even if bind 127.0.0.1 is commented out, an error will still be reported when accessing redisd, as shown below:

(error) DENIED Redis is running in protected mode because protected mode is enabled, no bind address was specified, no authentication password is requested to clients. In this mode connections are only accepted from the loopback interface. If you want to connect from external computers to Redis you may adopt one of the following solutions: 1) Just disable protected mode sending the command 'CONFIG SET protected-mode no' from the loopback interface by connecting to Redis from the same host the server is running, however MAKE SURE Redis is not publicly accessible from internet if you do so. Use CONFIG REWRITE to make this change permanent. 2) Alternatively you can just disable the protected mode by editing the Redis configuration file, and setting the protected mode option to 'no', and then restarting the server. 3) If you started the server manually just for testing, restart it with the'--protected-mode no' option. 4) Setup a bind address or an authentication password. NOTE: You only need to do one of the above things in order for the server to start accepting connections from the outside. The above is all the content of the article "how to make redis allow remote access". Thank you for reading! I believe we all have a certain understanding, hope to share the content to help you, if you want to learn more knowledge, welcome to follow the industry information channel!

Welcome to subscribe "Shulou Technology Information " to get latest news, interesting things and hot topics in the IT industry, and controls the hottest and latest Internet news, technology news and IT industry trends.