Shulou(Shulou.com)06/02 Report--

After the Hyper host is prepared, we begin the Hyper-V Cluster cluster configuration

Prepare to verify the Cluster cluster

1) Open Cluster Administrator and click "validate Configuration"

2) check "Do not show this page again" and click "next"

3) add at least 2 cluster nodes

4) check "Run all tests (recommended)" and click "next"

5) list the content to be verified by the cluster, and click "next"

Regardless of whether the verification is successful or not, a verification report will be generated to help solve the problem that the cluster verification fails. If the verification passes, we can start deploying the cluster.

Steps to deploy a Cluster cluster

1) create a two-node cluster, open Cluster Administrator, and click "Create Cluster..."

2) add cluster member servers

3) set the cluster name and IP address, and click "next"

4) tick off the "Add all eligible storage to the cluster" check box and click "next"

5) the following warning message appears because the quorum disk has not been configured when the cluster is created

6) set the network as shown in the following figure. 192. Cluster communication is not allowed.

7) set the network as shown in the figure below, but do not allow clients to access applications through this network.

8) set "Live Migration Setting …" The network uses "cluster network 1", as shown in the following figure.

9) add cluster shared disk

10) add CSV cluster shared volumes

Set up the arbitration disk

1) Open Cluster Administrator, right-click on the cluster name, and select "More Actions"-"Configure Cluster Quorum Settings …"

Welcome to subscribe "Shulou Technology Information " to get latest news, interesting things and hot topics in the IT industry, and controls the hottest and latest Internet news, technology news and IT industry trends.